Electrical impedance
In electrical engineering, impedance is the opposition to alternating current presented by the combined effect of resistance and reactance in a circuit.[1]
Quantitatively, the impedance of a two-terminal circuit element is the ratio of the complex representation of the sinusoidal voltage between its terminals, to the complex representation of the current flowing through it.[2] In general, it depends upon the frequency of the sinusoidal voltage.
Impedance extends the concept of resistance to alternating current (AC) circuits, and possesses both magnitude and phase, unlike resistance, which has only magnitude.
Impedance can be represented as a complex number, with the same units as resistance, for which the SI unit is the ohm (Ω).
Its symbol is usually Z, and it may be represented by writing its magnitude and phase in the polar form |Z|∠θ. However, Cartesian complex number representation is often more powerful for circuit analysis purposes.
The notion of impedance is useful for performing AC analysis of electrical networks, because it allows relating sinusoidal voltages and currents by a simple linear law.
In multiple port networks, the two-terminal definition of impedance is inadequate, but the complex voltages at the ports and the currents flowing through them are still linearly related by the impedance matrix.[3]
The reciprocal of impedance is admittance, whose SI unit is the siemens, formerly called mho.
Instruments used to measure the electrical impedance are called impedance analyzers.
History[edit]
Perhaps the earliest use of complex numbers in circuit analysis was by Johann Victor Wietlisbach in 1879 in analysing the Maxwell bridge. Wietlisbach avoided using differential equations by expressing AC currents and voltages as exponential functions with imaginary exponents (see § Validity of complex representation). Wietlisbach found the required voltage was given by multiplying the current by a complex number (impedance), although he did not identify this as a general parameter in its own right.[4]
The term impedance was coined by Oliver Heaviside in July 1886.[5][6] Heaviside recognised that the "resistance operator" (impedance) in his operational calculus was a complex number. In 1887 he showed that there was an AC equivalent to Ohm's law.[7]
Arthur Kennelly published an influential paper on impedance in 1893. Kennelly arrived at a complex number representation in a rather more direct way than using imaginary exponential functions. Kennelly followed the graphical representation of impedance (showing resistance, reactance, and impedance as the lengths of the sides of a right angle triangle) developed by John Ambrose Fleming in 1889. Impedances could thus be added vectorially. Kennelly realised that this graphical representation of impedance was directly analogous to graphical representation of complex numbers (Argand diagram). Problems in impedance calculation could thus be approached algebraically with a complex number representation.[8][9] Later that same year, Kennelly's work was generalised to all AC circuits by Charles Proteus Steinmetz. Steinmetz not only represented impedances by complex numbers but also voltages and currents. Unlike Kennelly, Steinmetz was thus able to express AC equivalents of DC laws such as Ohm's and Kirchhoff's laws.[10] Steinmetz's work was highly influential in spreading the technique amongst engineers.[11]
Introduction[edit]
In addition to resistance as seen in DC circuits, impedance in AC circuits includes the effects of the induction of voltages in conductors by the magnetic fields (inductance), and the electrostatic storage of charge induced by voltages between conductors (capacitance). The impedance caused by these two effects is collectively referred to as reactance and forms the imaginary part of complex impedance whereas resistance forms the real part.